Ozone Disinfection Machine Air/Water Purifier Customized Ozone output

Ozone Output 3500mg/h With Timer Control Ozone generator

Ozone Disinfection Machine Air/Water Purifier Customized Ozone output

Illustration:

specification:

Model	YL-S3500	Input Power	AC220V/50Hz
Working Power	3.0~3.5KV	Working Frenquency	8~10KV
Nominal Power	45W	Ozone output	1-3.5g/h
Ozone Density	8~10mg/L	Effective Area	≤300m2
Material	304stainless	Dimension	350x130x150mm

1. Ozone generator and control board are installed into one box type.body.

2. Out electrical pole is made of stainless and crystal used as medium. The discharge chamber is wholly sealed and it`s safe to operate.

3. PSU(Power Supply Unit) is this model product`s core technique including frequency conversion and boost converter. It applies soft start that can make high load capacity and multi-protection with high efficiency and stability.

4. This product should work with a clean air intake.

5. Discharge chamber is cooled by wind cooling system. It will make electric discharge well and ozone output stable without damaging components.

  

Use:

Prepare:

1. This product should work in a dry and ventilated room. If it must work outside, please shield it from direct sunshine and rain.

2. For air purification, it can work with a silicon pose linked and the other side led to the place.For water purification,it can work with a silicon linked and the other side put into water with a airstone.

3. Please make sure the silicon pose is in good condition for proper function.

NO	General fault	Fault Analysis	Solution
1	Power indicator off	1No power 2Fuse damaged 3Indicator damaged	1Link the power 2Change fuse 3change indicator
2	Working indicator off	1No power 2Fuse damaged 3Indicator damaged	1Link the power 2Change fuse 3change indicator
3	No ozone output	1Discharge bulb not work 2Silicon damaged 3Pump damaged	1Change discharge bulb or control circuit board 2Change silicon pose 3Change pump
4	small amount of ozone	1Discharge bulb aging 2Ozone bulb hot	1Change discharge bulb 2Change fan

Care and Maintenance

1. Please keep the surface of machine clean at regular period.

2. Please change the silicon pose when it is broken..

Note:

1. When for air purification, it is advised that people should avoid the sterilization area in case of respiratory system stimulation because of  high density of ozone.

2. For water purification, please instal with anti-reflux device in case of damaging machine.(It is advised to instal antioxidant normally closed valve at the pipeline and it`s power sychronise with ozone power.

3. This product`s voltage is 220V/50HZ and there is a high voltage inside.Please make sure there is a earth wire and avoid electric shock.

Ozone Disinfection Machine Air/Water Purifier Customized Ozone output